The bottom of the cod piece connects to the bottom of the butt plate with a single strap. The thighs are connected to the codpiece with a single strap on each side. There is also a loop on the bell that keeps it from flopping around. The foam gun is self-cleaning, ensuring a solid shot of foam every time. The shoulder bells connect to the shoulder straps with a single piece of elastic, and an additional strap is glued to the bottom edge of the bell that connects to the upper arm. The shins (not pictured) are held together by three straps on each side. I didn't get many pictures of the strapping process, as I was wrapped up with college at the time, but I'll try to explain it as best I can. After that's done, cut some elastic straps and and glue the chest and back together at the shoulders and sides. If you choose to use the latex caulking, lay down a line along the seam, and smooth it with a paper towel. Also carve a groove following the blue line shown on the codpiece. Patterns for building from EVA Foam Clone trooper body armor armor Make your own high detailed armor suit to wear. You'll also want to carve a groove down the center of the chest plate with the dremel. Hot glue the chest pieces together, and glue the craft foam pieces to the cardboard.
0 Comments
Leave a Reply. |